Sony GY-8240UWD Maintenance Manual page 339

For GY-8240FC
"
SETUP=> 1
*****[ SETUP INFORMATION SET ]*************************
Loop ID request(0:OFF/1:ON)
Loop ID (0-126)
IP address (0-255 each)
Subnet mask (0-255 each)
Gateway address (0-255 each)
Unload mode (0:NORMAL/1:FAST)
Auto load mode (0:OFF/1:ON)
Fast unload location (0:NORMAL/1:TOP) [0]
Auto format mode (0:OFF/1:ON)
On the halfway (0:OFF/1:ON)
Compression mode (0:SCSI/1:ON/2:OFF)
File mark flush mode(0:OFF/1:ON)
Recover TYPE (0-2)
Fast read mode (0:OFF/1:ON)
Are you sure?(Y:yes/N:no)=> y
1. Loop ID request
Function: Sets the hardware assigned loop ID request mode.
Setting:
0: No loop ID request mode
1: Loop ID request mode
2. Loop ID
Function: Sets the hardware assigned lop ID.
Setting: Values from 0 to 126 can be set.
3. IP address
Function: Sets the ID address.
Setting:
The area is divided into four blocks. Value between 0 and 255 is acceptable for each of the
four blocks.
Enter "." between each block.
4. Subnet mask
Function: Sets the subnet mask.
Setting:
The area is divided into four blocks. Value between 0 and 255 is acceptable for each of the
four blocks.
Enter "." between each block.
5. Gateway address
Function: Sets the gateway address.
Setting: The area is divided into four blocks. Value between 0 and 255 is acceptable for each of the
four blocks.
Enter "." between each block.
GY-8240UWD
GY-8240FC
[0]
[0]
[127. 0. 0. 1] => 127.0.0.1
[255.255.255. 0] => 255.255.255.0
[ 0. 0. 0. 0] => 0.0.0.0
[1]
[1]
[0]
[0]
[0]
[0]
[1]
[1]
Setup Information Set Execution Screen
=> 1
=> 3
=> 1
=> 1
=> 0
=> 1
=> 0
=> 1
=> 0
=> 1
=> 0
5-10. SETUP Mode
5-123