Sony GY-8240UWD Maintenance Manual page 177

Installation
6. Harness Soldering
Solder the harness disconnected in (2) of step 5 to
a new motor.
n
Solder a red harness to the side of marking "+" of
the motor.
7. Attaching the Motor Joint
(1) Pass the motor joint through the shaft of the
motor and temporarily tighten the set screw.
(2) Confirm that the clearance between the motor
joint and motor satisfies the specification
when the motor joint is pushed toward the
motor, and tighten the set screw.
Tightening torque: 60 x 10
{6 kgf.cm}
GY-8240UWD
GY-8240FC
_2
N.m
3-24. Cassette Compartment Motor Replacement
Cassette compartment motor
+marking
Harness (red)
Harness Soldering
Set screw
Cassette compartment motor
Motor joint
Motor joint
Cassette compartment motor
A
Spec.: 3.8 mm
Attach the Motor Joint
Harness (gray)
Press
A
4.2 mm
3-91