3-14. Reel Motor Plate Assembly Replacement
3-14. Reel Motor Plate Assembly Replacement
Outline
Replacement
1. Removing the SE-606 Board
2. Removing the ME Wire (T-side only)
3. Removing the Shaft Holder
4. Remove the Reel Motor Plate Assembly
5. Installing the Flexible Card Wire
6. Installing the Slide Shaft
7. Installing the Reel Motor Plate Assembly
8. Installing the ME Wire (T-side only)
9. Installing the Shaft Holder
10. Applying Grease to the Slide Shaft
Adjustment after Replacement
11. Confirming the Reel Brake Clearance (Refer to Section 3-12-3.)
12. Confirming the Reel Brake Release Amount (Refer to Section 3-12-4.)
13. Performing the Servo Adjustment
(Refer to Section 5-9-5.)
(All Motors, Tension Sensors Adj)
14. Confirming the Reel Motor Operation
(CH07: S, T Reel Motor Check)
(Refer to Section 5-4-13.)
3-52
GY-8240UWD
GY-8240FC