Sony GY-8240UWD Maintenance Manual page 143

9. Installing the Shaft Holder
Align the projection of the shaft holder with the
hole of the base plate and fix it with the screw.
10. Applying Grease on the Slide Shaft
(1) Apply a very small portion of grease on the
slide shaft and spread grease over the whole
shaft.
n
Use care not to put grease on other parts in
vicinity.
(2) Confirm that the reel motor plate assembly
moves smoothly when bringing to the S
cassette position and L cassette position.
Adjustment after Replacement
11. Confirming the Reel Brake Clearance
Refer to Section 3-12-3.
12. Confirming the Reel Brake Release
Amount
Refer to Section 3-12-4.
13. Performing Servo Adjustment
Refer to Section 5-9-5.
(All Motors, Tension Sensors Adj)
14. Confirming the Reel Motor Operation
Refer to Section 5-4-13.
(CH07: S, T Reel Motor Check)
GY-8240UWD
GY-8240FC
3-14. RS Table Block Assembly Replacement
PWH3 x 8
Shaft holder
Slide shaft
PWH3 x 8
Grease smearing
Install the Shaft Holder and Apply Grease
Shaft holder
Grease smearing
3-57