Confi Head Assembly Replacement - Sony GY-8240UWD Maintenance Manual

3-7. CONFI Head Assembly Replacement

3-7. CONFI Head Assembly Replacement
Outline
Replacement
1. Removing the CL Guide Rail (Refer to step 5 in Section 3-20.)
2. Disconnecting the Flexible Card Wire. (CN2/CT-205 Board)
3. Removing the CONFI Head Assembly.
4. Installing the CONFI Head Assembly.
5. Connecting the Flexible Card Wire. (CN2/CT-205 Board)
6. Installing the CL Guide Rail. (Refer to step 24 in Section 3-20.)
7. Cleaning (CONFI Head Surface)
Adjustment after Replacement
8. Adjusting the CONFI Head Height. (Refer to Section 4-9.)
9. Confirming the Tape Running. (Refer to Section 4-3.)
10. Confirming the Time Code Level in REV Mode. (Refer to Section 4-8.)
Tools
. Cleaning cloth:
. Cleaning fluid:
. Torque screwdriver (6 kg.cm) (JB-5251):
. Torque screwdriver's bit (+2 mm, l = 75 mm): J-6323-420-A
. Tape guide adjusting screwdriver (MW-261): J-6322-610-A
Preparation
1. Turn the power off and remove the power cord.
2. Remove the top panel. (Refer to Section 1-1.)
3. Remove the plate MD. (Refer to Section 1-2.)
4. Remove the cassette compartment. (Refer to Section 1-2.)
Removal
1. Removing the CL Guide Rail
Remove the CL guide rail.
Refer to step 5 in Section 3-20.
2. Disconnecting the Flexible Card Wire
Disconnect the flexible card wire from the
connector CN2 on the CT-205 board.
3-30
3-184-527-01
9-919-573-01
J-6252-510-A
CN2
CT-205 board
Disconnect the Flexible Card Wire
Flexible card wire
CONFI head assembly
GY-8240UWD
GY-8240FC