Sony GY-8240UWD Maintenance Manual page 133

6. Setting in the S Cassette Position
Rotate the gear of reel shift motor counterclock-
wise as far as it will go.
7. Checking the Supply and Take-up
Reel Table Height
Perform in the same way as in steps 4 and 5.
If the specification is not satisfied, perform steps
8 and later.
If the specifications are satisfied in both L and S
cassette positions, perform steps 10 and later.
Adjustment
8. Removing the Reel Table
9. Adjusting the Number of Poly-slider
Washers
Adjust the number of poly-slider washers in-
stalled in the reel motor shaft so that the specifi-
cations are satisfied in both L and S cassette
positions.
10. Removing the Cassette Reference
Plate (L)
Remove the cassette reference plate (L) and reel
table height gauge.
11. Tighten the Screws of the Reel Table
Assembly
Press down the caws of reel table assembly and
tighten the two set screws.
12. Rechecking the Reel Table Height
Refer to steps 3 through 7.
13. Installing the SE-606 Board
Install the SE-606 board.
(Refer to Section 3-14.)
GY-8240UWD
GY-8240FC
3-12. Reel Table Assembly Replacement and Adjustment
<S cassette position>
S reel table
Gear
Reel table
Flange
**
*
Spec.: The * marked portion of the gauge
slide over the flange of the reel table.
The ** marked portion of the gauge
does not slide over.
Reel Table Height Check (S)
Poly-slider washers
. Poly-slider washer for adjustment
Diameter Thickness
0.05 mm
0.13 mm
4 mm
0.25 mm
0.5 mm
Reel Table Height Adjustment
3-12-2. Reel Table Height Adjustment
T reel table
Reel table height gauge
Reel table height gauge
Cassette reference plate (L)
Reel table
Reel motor shaft
Part No.
3-188-108-01
3-701-441-01
3-701-441-11
3-701-441-21
3-47