Sony GY-8240UWD Maintenance Manual page 142

3-14. Reel Motor Plate Assembly Replacement
6. Installing the slide shaft
Insert the slide shaft removed in step 4 in the hole
of the reel motor plate assembly.
7. Installing the Reel Motor Plate
assembly
(1) Keeping the both states that the guide portion
of the reel motor plate assembly is aligned
with the notch of the plate holder assembly
and the pin of drive gear assembly will be
able to be insert between the limiter arm,
install the RS table block assembly.
(2) Insert the slide shaft in the motor holder
assembly.
8. Installing the ME Wire (T-side only)
(1) Pass the ME wire and the lug terminal
through the plate holder (T) assembly.
(2) Install the ME wire in the T drawer assembly
as shown in the figure and fix the lug termi-
nal with the screw.
(3) Hang the tip of the ME wire on the wire
holder of attachment fitting (C) and fix it.
3-56
Slide shaft
Flexible card wire
Pin
Install the Reel Motor Plate Assembly
Wire holder
T drawer assembly
Install the ME Wire
Reel motor plate assembly
Limiter arm
Motor holder assembly
PWH3 x 8
Lug terminal ME wire
Plate holder (T) assembly
GY-8240UWD
GY-8240FC