Sony GY-8240UWD Maintenance Manual page 364

5-13. Troubleshooting
Error Code Details
1xB1 XFER ABORT INT waiting time-out 1
1xB2 XFER ABORT INT waiting time-out 2
1xC0 EE up to processor of DPR-160 board failed.
1xC1 EE including EQ of DPR-160 board failed.
1xC2 EE (with CRC) up to processor of DPR-160 board failed.
1xC3 EE (with CRC) including EQ of DPR-160 board failed.
1xCF DIAG from other FMTs failed.
1xYY Other errors
2x01 Reached EOT during REC/PLAY.
2x02 Received illegal command by BOT.
2x03 Received illegal command by EOT
2x04 Received REC command for REC-inhibited cassette.
2x05 Aborted search.
2x06 Attempted to shift to illegal state.
2x0A Illegal cassette
2x10 Detected condensation.
2x14 Abnormal unit fan
2x15 Abnormal power supply fan
2x62 Detected different ID after detection of pre-IN point.
2x63 Lost lock occurred after detection of pre-IN point.
2x64 Exceeded IN-point during REC/PLAY.
2x65 CTL abnormal section detected before detection of pre-IN point.
2x66 Not CTL locked at pre-IN point during REC/PLAY.
2x67 Not AT locked at pre-IN point during REC/PLAY.
2x68 Not SV locked when crash REC was executed.
2x69 Detected EOT-BOT during search.
Continued to next page
5-148
Remedy
Software error
Replace FM-75 board.
Replace DPR-160 board or FM-75 board.
Replace FM-75 board.
Replace DPR-160 board or FM-75 board.
Replace FM-75 board.
Replace EOT sensor.
Replace BOT sensor.
Replace harness.
Replace FM-75 board.
Replace EOT sensor.
Replace harness.
Replace FM-75 board.
Replace FM-75 board.
Replace SV-205 board.
Replace FM-75 board.
Wait till released.
Replace dew sensor.
Replace FAN (large).
Replace FAN (small).
Unload and clean CTL/TC head.
Clean tape path system.
. Replace cassette.
. Replace CT-205 board.
. Replace harness.
Unload and clean CTL/TC head.
Clean tape path system.
. Replace cassette.
. Replace CT-205 board.
. Replace harness.
Unload cassette, load cleaning cassette,
and clean.
. Replace cassette.
. Replace drum.
. Replace DPR-160 board.
. Replace SV-205 board.
. Replace harness.
Replace SV-205 board.
Replace drum motor.
Unload and clean CTL/TC head.
Clean tape path.
. Replace cassette.
. Replace CT-205 board.
. Replace EOT and BOT sensors.
. Replace harness.
GY-8240UWD
GY-8240FC