Sony GY-8240UWD Maintenance Manual page 207

Adjustment
8. Remove the CL Guide Rail
Remove the two screws, then remove the CL
guide rail. (Refer to Step 5 in Section 3-20.)
9. Loosen the Screws
Loosen the two fixing screws (PSW3 x 8) of the
CTL/TC head assembly by 1/4 to 1/2 turn.
10. Adjust the CTL/TC Head Position
(1) Play back the YR2-1A (IDR: 0 to 200000)
with the REC head.
(2) Insert a 3 mm flatbladed screwdriver into the
notch of the CTL/TC head assembly.
(3) Adjust the CTL/TC head assembly position
so that the specification is satisfied.
11. Tighten the Screws
Tighten the two screws loosened in step 9.
12. Recheck the CTL/TC Head Position
Refer to steps 6 and 7 in this section.
13. Install the CL Guide Rail
Install the CL guide rail with two screws.
(Refer to Step 24 in Section 3-20.)
In case the adjustment is performed
14. Check the CTL/TC Head Height
Refer to Section 4-5.
15. Check the CTL/TC Head Azimuth
Refer to Section 4-6.
16. Check the CTL/TC Head Position
Refer to steps 6 and 7 in this section.
GY-8240UWD
GY-8240FC
PSW3 x 8
Notch
REC AE
(TP603/DPR-160)
REC AC SEL
(TP401/DPR-160)
TC26
(TP15/FM-75)
CTL/TC Head Position Adjustment
4-7. CTL/TC Head Position Adjustment
PSW3 x 8
CTL/TC head assembly
maximize
Marker
A ch C ch
4-27