Adjustment
8. In Case the Level Increases when the
Tape is Pressed Down (Fig. 1)
Turn the height adjustment screw clockwise and
adjust so that the output waveform is maximum.
9. In Case the Level Increases when the
Tape is Pushed Up (Fig. 2)
Turn the height adjustment screw counterclock-
wise and adjust so that the output waveform is
maximum.
In case the adjustment is performed
10. Adjust the CTL/TC Head Azimuth
Refer to Section 4-6.
11. Adjust the CTL/TC Head Position
Refer to Section 4-7.
12. Check the CTL/TC Head Height
Refer to steps 6 and 7 in this section.
13. Check the CTL/TC Head Azimuth
Refer to Section 4-6.
GY-8240UWD
GY-8240FC
<Fig. 1>
Height adjustment screw
<Fig. 2>
Height adjustment screw
CTL/TC Head Height Adjustment
4-5. CTL/TC Head Height Adjustment
maximize
maximize
4-21