Replacement Of Mechanical Parts; General Information For Parts Replacement; Notes - Sony GY-8240UWD Maintenance Manual

3-1. General Information for Parts Replacement

3-1-1. Notes

1. Tape Cleaner
c
Never touch the edge of the tape cleaner with bare hands.
A sharp edge of the tape cleaner may cause a hand cut.
Pay careful attention when replacing or adjusting the peripheral parts.
2. Grease and Oil
. Do not use ones other than the specified grease and oil. This may cause a trouble
or malfunction because of the difference in viscosity or components. Moreover, do
not use grease or oil in which dust is mixed. This may cause a trouble or malfunc-
tion.
. Grease (SGL-601): 7-651-000-10
. Oil:
7-661-018-18
. Apply just enough grease to form a thin film on the surface of the part.
Any grease left on the surrounding portions must be wiped with gauze or soft
cloth.
. A drop of oil is defined as follows:
About the amount that will remain on the tip of a stick of 2 mm in diameter, as
shown in the figure.
. Do not use the grease and oil except for specified portions.
3. Stop Washer
Do not reuse the removed stop washer.
. Stop washer (d = 2.3 mm): 3-669-596-00
GY-8240UWD
GY-8240FC
Section 3

Replacement of Mechanical Parts

2 mm
(diameter)
Oil
Oil
3-1