Downloading System Software (Assist Mode) - Canon imageRUNNER ADVANCE C350 series Service Manual

Procedure
1) Connect this machine and the PC with SST installed with the cross cable.
2) Turn ON the main power switch of this machine.
3) Enter service mode to start the machine in download mode.
COPIER > FUNCTION > SYSTEM > DOWNLOAD; and press [OK].
4) Check the IP address of the PC.
Go to Start menu to select the following: Program > Accessory > Command Prompt.
Type IPCONFIG and press the [Return] key to see the network settings of the PC.
If any discrepancies from the description in the figure below are found, change the network
settings of the PC.
CAUTION:
The network settings cannot be shown with IPCONFIG if the PC is disconnected from
the network. To check the settings, ensure that this machine is turned ON, and connect
the PC and this machine with the cross cable.
6
Troubleshooting > Version Upgrade > Version Upgrade via SST > Downloading System Software (Assist mode)
F-6-24
6 Troubleshooting > Version Upgrade > Version Upgrade via SST > Downloading System Software (Assist mode)

■ Downloading System Software (Assist mode)

1) Start this machine and enter download mode. (COPIER > FUNCTION > SYSTEM >
DOWNLOAD)
2) Connect the PC to this machine and start SST.
3) Click the "Start Assist Mode" button.
Skip this step when starting SST in assist mode.
If newer combination of the system software is stored in SST, the new combination is
automatically selected.
NOTE:
If only the existing system software combination is stored, none of them are selected.
Any versions of the existing system software can be downloaded by manual selection.
6-23
F-6-25
6-23