Canon imageRUNNER ADVANCE C350 series Service Manual page 648

Error Detail
Location Item
code Code
E025 0410 05 Title Bottle Motor (CK) error (Bk)
Detection The Bottle Rotation Sensor (Bk) did not detect rotation for 5
description times in a row although 1.5 sec (2 sec in the case of right before
replacement of the Toner Container) has passed after the Bottle
Motor (CK) was turned ON.
Remedy [Related parts]
- Toner Container (Bk)
- Harness between the DC Controller PCB (UN04/J155) and the
Bottle Motor (CK) (M10/J6302) (Unit of replacement: CABLE,
MAIN)
- Harnesses from the DC Controller PCB to the Bottle Rotation
Sensor (Bk)
1. DC Controller PCB (UN04/J151) to Relay Connector (3P)
(Unit of replacement: CABLE, MAIN)
2. Relay Connector (3P) to Bottle Rotation Sensor (Bk) (PS09/
J5304) (Unit of replacement: CABLE, BOTTLE SENSOR, M/K)
- Bottle Rotation Sensor (Bk) (PS09) (Unit of replacement:
PHOTO INTERRUPTER)
- DC Controller PCB (UN04) (Unit of replacement: DC
CONTROLLER PCB ASSEMBLY)
- Bottle Drive Unit (CK) (Unit of replacement: BOTTLE DRIVE
ASSEMBLY)
- Hopper Unit (Bk) (Unit of replacement: HOPPER ASSEMBLY)
[Points to note at work]
- Be sure to turn over the Door Lock Lever when removing the
Bottle Drive Unit (CK) and rotating the drive section by hand.
- When checking the harness/cable or connector, perform the
following work.
1. Disconnect and then connect the connector to check that
there is no bent pin and cable disconnection.
2. Visually check that the harness is not caught or open circuit.
3. If there is any error, replace the corresponding harness/
cable.
[Remedy] Check/replace the related parts.
[Reference] Before replacing the DC Controller PCB, back up
the service mode data (approx. 2 min) and restore the backup
data after the replacement so the data may be able to be
protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM>
DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM>
DSRAMRES
7
Error•Jam•Alarm > Error Code > Error Code Details
Description
7 Error•Jam•Alarm > Error Code > Error Code Details
Error Detail
Location Item
code Code
E025 0468 05 Title No toner detection error (Bk)
Detection The state without toner was detected although the recovery
description sequence was performed for 5 times after replacement of the
Toner Container (Bk).
Remedy [Related parts]
- Main Drive Unit (Unit of replacement: MAIN DRIVE
ASSEMBLY)
- Hopper Unit (Bk) (Unit of replacement: HOPPER ASSEMBLY)
- Toner Bottle Mount Unit (Bk) (Unit of replacement: BOTTLE
MOUNT ASSEMBLY)
- Drum Unit (Bk) (Unit of replacement: P-UNIT_BK)
- Toner Container (Bk)
[Remedy] Check/replace the related parts.
[Reference] If a user inserts an empty Toner Container (Bk)
repeatedly, the error may occur.
7-34
Description
7-34