Canon imageRUNNER ADVANCE C350 series Service Manual page 439

4
Disassembly/Assembly > Image Formation System > Removing the ITB Pressure Release Switch > Procedure
Removing the ITB Pressure Release Switch
■ Preparation
1) Remove the Rear Cover 1(Refer to page 4-35).
2) Remove the Left Upper Cover (to be removed for models equipped with a fax)
(Refer to page 4-37).
3) Remove the Fax Speaker Unit (to be removed for models equipped with a fax)
(Refer to page 4-105).
4) Remove the Fax Unit (to be removed for models equipped with a fax)(Refer to page 4-105).
5) Remove the Main Controller Unit(Refer to page 4-84).
6) Remove the Low-voltage Power Supply PCB Unit(Refer to page 4-97).
7) Remove the DC Controller PCB Unit(Refer to page 4-91).
8) Remove the Main Drive Unit(Refer to page 4-127).
4 Disassembly/Assembly > Image Formation System > Removing the ITB Pressure Release Switch > Procedure
F-4-334
■ Procedure
1) Remove the ITB Pressure Release Switch [1].
• 1 Connector [2]
• Harness Guide [A]
• 1 Claw [3]
• 2 Hooks [4]
4-132
[2] [4]
1x
1x
[3]
1x
[A]
[4]
[1]
F-4-335
4-132