Canon imageRUNNER ADVANCE C350 series Service Manual page 683

Error Detail
Location Item
code Code
E240 0D00 00 Title Controller communication error
Detection A sequence error with the controller occurred.
description
Remedy [Related parts]
- Flexible Cable between the DC Controller PCB (UN04/
J112) and the Main Controller PCB (UN81/J7001) (Unit of
replacement: CABLE, FLAT)
- DC Controller PCB (UN04) (Unit of replacement: DC
CONTROLLER PCB ASSEMBLY)
- Main Controller PCB (UN81) (Unit of replacement: MAIN
CONTROLLER PCB ASSEMBLY)
[Points to note at work] When checking the harness/cable or
connector, perform the following work.
1. Disconnect and then connect the connector to check that
there is no bent pin and cable disconnection.
2. Visually check that the harness is not caught or open circuit.
3. If there is any error, replace the corresponding harness/cable.
[Remedy] Perform the following in the order while checking
whether the error is cleared.
1. Check the harness between the DC Controller PCB and the
Main Controller PCB.
2. Turn ON the power, and check if the initialization is executed
at startup.
2-1. If the initialization is not executed, replace the DC
Controller PCB.
2-2. If the initialization is executed, replace the Main Controller
PCB.
[Reference] Before replacing the DC Controller PCB, back up
the service mode data (approx. 2 min) and restore the backup
data after the replacement so the data may be able to be
protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM>
DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM>
DSRAMRES
E246 0001 00 Title System error
Detection System error
description
Remedy Contact to the sales company.
E246 0002 00 Title System error
Detection System error
description
Remedy Contact to the sales company.
7
Error•Jam•Alarm > Error Code > Error Code Details
Description
7 Error•Jam•Alarm > Error Code > Error Code Details
Error Detail
Location Item
code Code
E246 0003 00 Title System error
Detection System error
description
Remedy Contact to the sales company.
E246 0005 00 Title System error
Detection System error
description
Remedy Contact to the sales company.
E247 0001 00 Title System error
Detection System error
description
Remedy Contact to the sales company.
E247 0002 00 Title System error
Detection System error
description
Remedy Contact to the sales company.
E247 0003 00 Title System error
Detection System error
description
Remedy Contact to the sales company.
E247 0004 00 Title System error
Detection System error
description
Remedy Contact to the sales company.
E248 0001 04 Title Reader backup error
Detection Reading error was detected when the Controller IC of the Main
description Controller PCB read the Reader backup value in the Flash PCB.
Remedy [Related parts] Flash PCB (UN96)
[Remedy] Perform the following in the order while checking
whether the error is cleared. After performing the remedy, enter
the value of the service label again.
1. After executing "COPIER> FUNCTION> CLEAR> R-CON",
turn OFF and then ON the main power, and check whether the
error is cleared.
2. After replacing the Flash PCB, reinstall the system software
using SST or a USB memory.
7-69
Description
7-69