Canon imageRUNNER ADVANCE C350 series Service Manual page 441

4
Disassembly/Assembly > Image Formation System > Removing the Toner Bottle Mount (Y/M/C/Bk) > Preparation (for the Toner Bottle Mount (Y/M/C))
NOTE: How to install the Bottle Drive Unit (C Bk)
Be sure to align the hole [A] of the gear with the protrusion [B] of the shaft to install the
unit.
[A] [B]
4 Disassembly/Assembly > Image Formation System > Removing the Toner Bottle Mount (Y/M/C/Bk) > Preparation (for the Toner Bottle Mount (Y/M/C))
Removing the Toner Bottle Mount (Y/M/C/Bk)
■ Preparation (for the Toner Bottle Mount (Y/M/C))
1) Remove the Rear Cover 1(Refer to page 4-35).
2) Remove the Left Upper Cover(Refer to page 4-37).
3) Remove the Fax Speaker Unit (to be removed for models equipped with a fax)
(Refer to page 4-105).
4) Remove the Fax Unit (to be removed for models equipped with a fax)(Refer to page 4-105).
5) Remove the Main Controller Unit(Refer to page 4-84).
6) Remove the Low-voltage Power Supply PCB Unit(Refer to page 4-97).
7) Remove the DC Controller PCB Unit(Refer to page 4-91).
8) Remove the Main Drive Unit(Refer to page 4-127).
9) Remove the Waste Toner Container(Refer to page 4-112).
10) Remove the Toner Container (Y/M/C/Bk) (remove the toner container of the color to be
removed)(Refer to page 4-113).
11) Remove the Drum Unit (Y/M/C/Bk) (remove the drum Unit of the color to be removed)
(Refer to page 4-113).
12) Remove the ITB Unit(Refer to page 4-115).
F-4-340
13) Remove the Left Lower Cover(Refer to page 4-37).
14) Remove the Primary Transfer High-voltage PCB Unit(Refer to page 4-95).
15) Free the harness [1] from the Harness Guide [A] of the High-voltage Contact Unit.
4-134
F-4-341
4-134