Initialization Procedure - Canon imageRUNNER ADVANCE C350 series Service Manual

2
Technical Explanation > Embedded RDS > E-RDS Setup > Initializing E-RDS settings
3) Turn OFF and then ON the main power of this machine.
4) Make sure that "1 (: ACTIVE)" is set under [COPIER] > [Display] > [USER] > [BRWS-STS].
5) When the above-shown setting values are enabled, [Service Browser] is displayed in the
Service Mode screen.
NOTE:
Generally, once service browsing is enabled, to stop the service browsing, execute
BRWS-ACT again, turn OFF and then ON the main power of this machine.
2 Technical Explanation > Embedded RDS > E-RDS Setup > Initializing E-RDS settings
■ Initializing E-RDS settings
It is possible to clear the FLASH data of E-RDS and change the E-RDS setting back to the
default value.
● Initialization procedure
1) Start [Service Mode] at Level 1.
2) Select [COPIER] > [Function] > [CLEAR] > [ERDS-DAT] and then touch [OK].
F-2-369
● Setting values and data to be initialized
The following E-RDS settings, internal data, and Alarm filtering information are initialized.
CAUTION:
In case of replacing the CA certificate file, even if initialization of E-RDS is executed, the
F-2-370
status is not returned to the factory default.
When installing the certificate file other than the factory default CA certificate file, it is
required to delete the certificate file after E-RDS initialization and install the factory
default CA certificate file.
For detailed procedures, see "Steps to E-RDS settings - step 3.".
• COPIER > Function > INSTALL > E-RDS
• COPIER > Function > INSTALL > RGW-ADR
• COPIER > Function > INSTALL > RGW-PORT
• COPIER > Function > INSTALL > COM-LOG
2-210
F-2-371
2-210