Canon imageRUNNER ADVANCE C350 series Service Manual page 547

● SST to USB memory storage device
Register the system software registered in SST to the USB memory storage device.
NOTE:
Although only one version of software can be saved with the existing machines, multiple
versions of software can be saved simultaneously in the USB memory storage device
with this machine (up to 9 versions of software can be saved)
Preparation
Requirements:
• PC with SST Ver.4.73 or later installed
• USB memory storage device (*)
*: Requirements for USB memory storage devices
Interface: USB1.1 or later (USB2.0 is recommended)
Memory capacity: 1GB or more is recommended (the total file size of the system software
is approx. 350MB)
Format: FAT (FAT16), FAT32 (NTFS and HFS are not supported). The memory is formatted
in a partition (multiple partitions are not supported)
Unusable USB memory storage device: the memory that is protected by a password or the
encryption technology.
Steps to register the system software
1) Start the PC.
2) Insert the USB memory storage device to the USB port of the PC.
3) Start SST.
6
Troubleshooting > Version Upgrade > Version Upgrade using USB Memory Storage Device > Registering System Software
6 Troubleshooting > Version Upgrade > Version Upgrade using USB Memory Storage Device > Registering System Software
4) Click the USB icon shown in "Select the target" screen.
5) Select the drive (removable disk) where the USB memory storage device is inserted.
6-36
F-6-52
F-6-53
6-36