This machine have the following test print TYPE and you can judge the image failure that is checked as "Yes" in the following image check items with each test print.
If the image failure occurred on normal output does not reappear on the test print, it may be caused by the PDL input or reader side.
PG
TYPE Pattern
TYPE
0
Normal copy / print
1to3
---(For R&D)
4
16 gradations
5
Full half-tone
6
Grid
7to9
---(For R&D)
10
MCYBk horizontal stripes
(sub scanning direction)
11
---(For R&D)
12
64-gradation
13
---(For R&D)
14
Full color 16-gradation
15to100 ---(For R&D)
Steps to select the test print TYPE
1) Set the number of print, paper size etc.
2) Select: COPIER > TEST > PG.
3) Select: COPIER > TEST > PG > TYPE.
4) Enter the desired TYPE number and press OK key.
5) Select the corresponding color (setting 1 means output) in COLOR-Y/M/C/K.
6) Set the density in DENS-Y/M/C/K (this is enabled for TYPE=5 only).
7) Press start key.
6
Troubleshooting > Test Print > Steps to select the test print TYPE
Transfer
Black line
Gradation
Fogging
Fault
(Color line)
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
6
Troubleshooting > Test Print > Steps to select the test print TYPE