Canon imageRUNNER ADVANCE C350 series Service Manual page 693

Error Detail
Location Item
code Code
E602 0301 00 Title HDD error
Detection Error in MEAP-related area (Initialization failed at startup, or I/O
description error at startup)
When this error occurs, the system has not been started
normally. Therefore, it may not be recorded in the error log.
Remedy [Related parts]
- Cable between the Main Controller PCB (UN81/J7008 and
J7018) and the HDD (Unit of replacement: CABLE, SATA
POWER, CABLE, SATA SIGNAL)
- HDD (Unit of replacement: HARD DISK DRIVE)
- Main Controller PCB (UN81) (Unit of replacement: MAIN
CONTROLLER PCB ASSEMBLY)
[Points to note at work]
- When checking the harness/cable or connector, perform the
following work.
1. Disconnect and then connect the connector to check that
there is no bent pin and cable disconnection.
2. Visually check that the harness is not caught or open circuit.
3. If there is any error, replace the corresponding harness/
cable.
- Reinstall the necessary application software and restore the
backup data once the error is cleared.
- To delete MEAP area, the special license is issued by the
sales company as needed.
Remedy [Related parts]
- Cable between the Main Controller PCB (UN81/J7008 and
J7018) and the HDD (Unit of replacement: CABLE, SATA
POWER, CABLE, SATA SIGNAL)
- HDD (Unit of replacement: HARD DISK DRIVE)
- Main Controller PCB (UN81) (Unit of replacement: MAIN
CONTROLLER PCB ASSEMBLY)
[Points to note at work]
- When checking the harness/cable or connector, perform the
following work.
1. Disconnect and then connect the connector to check that
there is no bent pin and cable disconnection.
2. Visually check that the harness is not caught or open circuit.
3. If there is any error, replace the corresponding harness/
cable.
- Reinstall the necessary application software and restore the
backup data once the error is cleared.
- To delete MEAP area, the special license is issued by the
sales company as needed.
7
Error•Jam•Alarm > Error Code > Error Code Details
Description
7 Error•Jam•Alarm > Error Code > Error Code Details
Error Detail
Location Item
code Code
E602 0311 00 Title HDD error
Detection Error in MEAP-related area (file could not be written in the HDD
description after startup, or I/O error after startup)
Remedy [Related parts]
- Cable between the Main Controller PCB (UN81/J7008 and
J7018) and the HDD (Unit of replacement: CABLE, SATA
POWER, CABLE, SATA SIGNAL)
- HDD (Unit of replacement: HARD DISK DRIVE)
- Main Controller PCB (UN81) (Unit of replacement: MAIN
CONTROLLER PCB ASSEMBLY)
[Points to note at work]
- When checking the harness/cable or connector, perform the
following work.
1. Disconnect and then connect the connector to check that
there is no bent pin and cable disconnection.
2. Visually check that the harness is not caught or open circuit.
3. If there is any error, replace the corresponding harness/
cable.
- Reinstall the necessary application software and restore the
backup data once the error is cleared.
- To delete MEAP area, the special license is issued by the
sales company as needed.
7-79
Description
7-79