Canon imageRUNNER ADVANCE C350 series Service Manual page 727

Error Detail
Location Item
code Code
E614 9000 00 Title Error in file system on the Flash PCB
Detection SRAM device access-related error (at startup)
description When this error occurs, the system has not been started
normally. Therefore, it may not be recorded in the error log.
Remedy [Related parts] Flash PCB (UN96)
[Remedy] Perform the following in the order while checking
whether the error is cleared.
1. Disconnect and then connect the connectors of the Flash
PCB and the Main Power Switch, and check if there is any bent
pin or cable disconnection.
2. Format the system.
2-1. Enter safe mode using (2+8) startup, and execute [4]
Clear/Format> [2] Flash Format (Flash format) using a USB
memory.
2-2. Reinstall the system software using SST or a USB
memory.
3. After replacing the Flash PCB, reinstall the system software
using SST or a USB memory.
E614 9001 00 Title Error in file system on the Flash PCB
Detection Error in securing memory/invalid memory (at startup)
description When this error occurs, the system has not been started
normally. Therefore, it may not be recorded in the error log.
Remedy [Related parts] Flash PCB (UN96)
[Remedy] Perform the following in the order while checking
whether the error is cleared.
1. Disconnect and then connect the connectors of the Flash
PCB and the Main Power Switch, and check if there is any bent
pin or cable disconnection.
2. Format the system.
2-1. Enter safe mode using (2+8) startup, and execute [4]
Clear/Format> [2] Flash Format (Flash format) using a USB
memory.
2-2. Reinstall the system software using SST or a USB
memory.
3. After replacing the Flash PCB, reinstall the system software
using SST or a USB memory.
7
Error•Jam•Alarm > Error Code > Error Code Details
Description
7 Error•Jam•Alarm > Error Code > Error Code Details
Error Detail
Location Item
code Code
E614 9002 00 Title Error in file system on the Flash PCB
Detection Setting file error was detected at startup.
description When this error occurs, the system has not been started
normally. Therefore, it may not be recorded in the error log.
Remedy [Related parts] Flash PCB (UN96)
[Remedy] Perform the following in the order while checking
whether the error is cleared.
1. Disconnect and then connect the connectors of the Flash
PCB and the Main Power Switch, and check if there is any bent
pin or cable disconnection.
2. Format the system.
2-1. Enter safe mode using (2+8) startup, and execute [4]
Clear/Format> [2] Flash Format (Flash format) using a USB
memory.
2-2. Reinstall the system software using SST or a USB
memory.
3. After replacing the Flash PCB, reinstall the system software
using SST or a USB memory.
E614 9003 00 Title Error in file system on the Flash PCB
Detection Parameter error was detected at startup.
description When this error occurs, the system has not been started
normally. Therefore, it may not be recorded in the error log.
Remedy [Related parts] Flash PCB (UN96)
[Remedy] Perform the following in the order while checking
whether the error is cleared.
1. Disconnect and then connect the connectors of the Flash
PCB and the Main Power Switch, and check if there is any bent
pin or cable disconnection.
2. Format the system.
2-1. Enter safe mode using (2+8) startup, and execute [4]
Clear/Format> [2] Flash Format (Flash format) using a USB
memory.
2-2. Reinstall the system software using SST or a USB
memory.
3. After replacing the Flash PCB, reinstall the system software
using SST or a USB memory.
7-113
Description
7-113