Canon imageRUNNER ADVANCE C350 series Service Manual page 976

SORTER
ADJUST
SORTER> ADJUST
ST-ALG1 Adjustment of alignment position
Lv.1 Details To adjust the alignment position.
As the value is incremented by 1, the travel length of the Alignment
Plate is increased by 0.25 mm.
Use case - When misalignment occurs
- When adjusting the alignment position according to paper width
and degree of paper curl
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Caution Be sure to make an adjustment according to the paper width the user
uses and degree of curl.
Display/adj/set range -20 to 20
Unit 0.25 mm
Default value 0
8
Service Mode > SORTER > OPTION
T-8-71
8 Service Mode > SORTER > OPTION
OPTION
SORTER> OPTION
MD-SPRTN Set restriction at Finisher error
Lv.1 Details To set whether to stop the machine when an error occurs at Finisher.
Use case When preferring to run the machine at Finisher error
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution When "1" is set, staple operation or alignment operation is not
executed. Set "0" normally.
Display/adj/set range 0 to 1
0: Normal, 1: Function restriction
Default value 0
8-206
T-8-72
8-206