Canon imageRUNNER ADVANCE C350 series Service Manual page 252

2
Technical Explanation > Embedded RDS > E-RDS Setup > Steps to Service Browser settings
If the communication is successful, "OK!" is displayed. If "NG!" (failed) appears, refer to the
"Troubleshooting" and repeat until "OK!" is displayed.
NOTE:
The communication results with UGW can be distinguished by referring to the COM-
LOG. By performing the communication test with UGW, E-RDS acquires schedule
information and starts monitoring and meter reads operation.
2 Technical Explanation > Embedded RDS > E-RDS Setup > Steps to Service Browser settings
■ Steps to Service Browser settings
1) Start [Service Mode] at Level 1.
2) Select [COPIER] > [Function] > [INSTALL] > [BRWS-ACT] and then touch [OK].
NOTE:
When the status of the service browser is changed to enabled, E-RDS sends the
browser information to the UGW at this timing.
F-2-366
If the connection is established with UGW successfully, "OK!" is displayed. When "NG!" is
displayed, perform the steps referring to "Troubleshooting" until connection is established
with UGW.
2-209
F-2-367
F-2-368
2-209