Canon imageRUNNER ADVANCE C350 series Service Manual page 142

2
Technical Explanation > Fixing System > Service Tasks > Periodical Servicing
Code
E009 Film unit engagement / disengagement error
0001 The pressure release sensor signal could not be detected at pressure
application operation, and the operation was not completed within the
specified period of time from the start of counterclockwise rotation of the
Fixing Motor.
0002 The pressure release sensor signal could not be detected at pressure
release operation, and the operation was not completed within the
specified period of time from the start of counterclockwise rotation of the
Fixing Motor.
0003 The pressure release sensor signal could not be detected at pressure
application operation, and the operation was not completed within the
specified period of time from the start of counterclockwise rotation of the
Fixing Motor.
0004 The pressure release sensor signal could not be detected at pressure
release operation, and the operation was not completed within the
specified period of time from the start of counterclockwise rotation of the
Fixing Motor.
E808 Error in zero cross signal
0001 An electrical trouble caused by zero cross signal error.
0002 An electrical trouble caused by zero cross signal error.
● Remedy at occurrence of the Fixing Assembly error (E001/E002/
E003)
Previously, if the error (E001/E002/E003) relating to the Fixing Assembly occurred, a service
visit was necessary to clear the error in service mode (COPIER > FUNCTION > CLEAR >
ERR). (This included an incidental error occurrence.)
This machine treats E001/E002/E003 errors as follows to avoid a service visit just for clearing
these errors.
• 1st error detection: The error avoidance jam (00-0CF1) is displayed.
• 2nd and later error detection: An error code (E001/E002/E003) is displayed. (Detail Code:
Axxx*)
• If the issue occurred incidentally: The error can be recovered by turning OFF and then
ON the main power switch.
• If there is an issue with the Fixing Assembly: The same error is displayed after turning
OFF and then ON the main power switch.
* 1st digit of detail code is "A": This indicates that "clearing the error in service mode
(COPIER > FUNCTION > CLEAR > ERR) is unnecessary".
2 Technical Explanation > Fixing System > Service Tasks > Periodical Servicing
Clearing
Description
of error
Not
required
Not
required
Not
required
Not
required
Not
required
Not
required
Service Tasks
■ Periodically Replaced Parts
None.
■ Consumable Parts
No. Parts name
1 Fixing Assembly
■ Periodical Servicing
None.
Perform as needed.
T-2-47
Parts number Quantity Estimated life
FM0-0033(100V) 1 30,000 sheets
FM0-0072(120V)
FM0-0073(230V)
2-99
Remarks
T-2-48
2-99