Settings After Installation - Canon imageRUNNER ADVANCE C350 series Service Manual

22) Put the Card Reader Relay Harness through the Cord Guides, and install the covers
of the guides.
2x
23) Connect the power plug to the outlet.
24) Turn ON the main power switch.
9
Installation > Copy Card Reader-F1 > Settings after installation
F-9-60
9 Installation > Copy Card Reader-F1 > Settings after installation

Settings after installation

1) Set the model of the Card Reader in service mode.
• Check that the setting value is "0" in the following service mode (Level 1): COPIER >
OPTION > ACC > CR-TYPE.
2) Set the number of card (number of department ID) that can be used with the Card Reader
in service mode.
• Set any value in the following service mode (Level 2): COPIER > OPTION > FNC-SW >
CARD-RNG.
3) Enter the card number to be used (1 to 2001) in the following service mode (Level 1):
COPIER > FUNCTION > INSTALL > CARD.
• Enter the smallest card number to be used by the user.
• From the entered card number, 1000 cards can be used.
4) Turn OFF and then ON the main power switch to enable the setting value.
5) Insert a card with a card number that has been registered, and check that the machine
operates normally.
NOTE:
Perform the following operations to change the number of cards (departments) after it
has been set. In such a case, counter information for each department is reset.
• Execute the following service mode (Level 1): COPIER > FUNCTION > CLEAR > CARD.
• Execute the following service mode (Level 2): COPIER > OPTION > FNC-SW > CARD-
RNG.
• Turn OFF and then ON the main power switch to enable the setting value.
• After that, perform from step 3.
9-24
9-24