Canon imageRUNNER ADVANCE C350 series Service Manual page 510

5
Adjustment > Pickup Feed System > Multi-purpose Tray Left Edge Margin Adjustment (2nd side; Software Adjsutment)
Cassette Left Edge Margin Adjustment (2nd side;
Software Adjsutment)
Adjustment 1) Make 2-sided copy from cassette 1, and check that the left margin on the 2nd side
procedure is 2.5 ± 2.0 mm (for LTR/LGL: 4.2 ± 2.0 mm).
Feeding direction
of paper
2) If the left margin is out of the specification, change the adjustment value for the left
margin on the 2nd side in cassettte 1.
Service Mode > COPIER > ADJUST > FEED-ADJ > ADJ-C1RE; 1 increment of
the value spreads out the left margin by 0.1 mm. (Image move to the right)
3) Make 2-sided copy using the Cassette 1, and check that the left edge margin is 2.5
± 2.0 mm.
4) Write down the new adjustment value on the service label.
• ADJ-C1RE
5) Exit from Service Mode.
5 Adjustment > Pickup Feed System > Multi-purpose Tray Left Edge Margin Adjustment (2nd side; Software Adjsutment)
image
T-5-59
Multi-purpose Tray Left Edge Margin Adjustment (1st
side; Software Adjsutment)
Adjustment 1) Make copies from the Multi Purpose Tray, and check that the left margin on the 1st
procedure side is 2.5 ± 1.5 mm for LTR/LGL: 4.2 ± 1.5 mm).
2) If the left margin is out of the specification, change the adjustment value for the left
margin on the 1st side from the Multi Purpose Tray.
Service Mode > COPIER > ADJUST > FEED-ADJ > ADJ-MF; 1 increment of the
value spreads out the left margin by 0.1 mm. (Image move to the right)
3) Write down the new adjustment value on the service label.
• ADJ-MF
Multi-purpose Tray Left Edge Margin Adjustment (2nd
side; Software Adjsutment)
Adjustment 1) Make 2-sided copy from the Multi Purpose Tray, and check that the left margin on
procedure the 2nd side is 2.5 ± 2.0 mm for LTR/LGL: 4.2 ± 2.0 mm).
2) If the left margin is out of the specification, change the adjustment value for the left
margin on the 2nd side from the Multi Purpose Tray.
Service Mode > COPIER > ADJUST > FEED-ADJ > ADJ-MFRE ; 1 increment of
the value spreads out the left margin by 0.1 mm. (Image move to the right)
3) Write down the new adjustment value on the service label.
• ADJ-MFRE
5-21
T-5-60
T-5-61
5-21