3) Install the Serial RS Conversion Board.
• 1 Connector
• 2 Hexagon Screws
• 2 Washers
• 2 Screws (Use the screws removed in step 1.)
4x
9
Installation > Serial Interface Kit-K2 / Copy Control Interface Kit-A1 > Installation Procedure > Installing the Copy Control Interface Kit-A1
■ Installing the Copy Control Interface Kit-A1
1) Remove the Face Plate. (Removed Face Plate will not be used.)
• 2 Screws (Removed screws will be not be used.)
F-9-29
2) Pass the connector of the CC-VI Cable through the D-SUB Support Plate.
CAUTION:
Install the extruded side of the D-SUB Support Plate as shown in the figure.
9
Installation > Serial Interface Kit-K2 / Copy Control Interface Kit-A1 > Installation Procedure > Installing the Copy Control Interface Kit-A1
2x
ビス穴
突起
9-13
F-9-30
F-9-31
9-13