Detailed Jam Codes(Finisher) - Canon imageRUNNER ADVANCE C350 series Service Manual

Table of Contents

■ Detailed Jam Codes(Finisher)

Buffer Sensor

Buffer Sensor

Buffer Sensor

Early arrival

Buffer Sensor

Feed Path Sensor

Feed Path Sensor

Feed Path Sensor

Feed Path Sensor

Staple HP Sensor

Front Alignment

Staple Motor

Rear Alignment

Stack Tray Shift

Gripper Motor

Paddle Motor

Tray Auxiliary Guide

Error•Jam•Alarm > Jam Code > Jam Type > Detailed Jam Codes(Finisher)

Detected when the Buffer Sensor (S1) does not detect paper after lapse of the specified

time since reception of a paper delivery signal from the host machine.

Detected when the Buffer Sensor (S1) detects paper during power-on.

Detected when the front door is opened while paper is being fed (the Buffer Sensor (S1)

detects paper).

Detected when the Buffer Sensor (S1) detects paper without receiving a delivery signal

from the host machine.

Or detected when the Buffer Sensor (S1) detects paper earlier than the specified timing

after reception of a delivery signal from the host machine.

Detected when the Feed Path Sensor (S2) does not detect paper after lapse of the

specified time since detection of paper by the Buffer Sensor (S1).

Detected when the Feed Path Sensor (S2) does not turn off after lapse of the specified

time since detection of paper by the Feed Path Sensor (S2).

Detected when the Feed Path Sensor (S2) detects paper during power-on.

Detected when the front door is opened while paper is being fed (the Feed Path Sensor

(S2) detects paper).

Detected when the staple HP sensor (S11) cannot detect the stapler again even after the

specified time has lapsed since the stapler passed through the staple HP sensor (S11)

when stapling is executed.

Or detected when the staple edging sensor (S12) cannot detect a staple even when

recovery operation is performed ten times when staple edging is executed.