Omron CS1W-MC221 - 02-2008 Operation Manual page 301

Interface Specifics
Programming Example
Block end condition
R1
n+3, 04
Forced Block
End Bit
Pause Bits
274
n+15, 04/n+23, 04
Program
Execution
Flag
Word
MC221 MC421
n+3
n+5
--- n+7
--- n+9
These bits are used to temporarily pause program execution.
When a bit is turned ON, the block being executed will be interrupted and any
axes that are operating will be decelerated to a stop.
Operation is restarted by turning ON the Cycle Start Bit. The program that
was paused will be executed as long as the Program Number Read Bit is OFF.
Operation of the Cycle Start Bit is disabled as long as the Pause Bit is ON.
(The program won't be executed when the Cycle Start Bit is turned ON if the
Pause Bit is ON.)
The Pause Bits have a lower priority than the Forced Block End Bits. If both of
these bits go ON at the same time, the block will be ended.
Keep the Pause Bit ON until the Program Execution Flag turns OFF.
Signal
Pauses execution of the block being executed.
1 As long as the bit remains ON, the program won't be executed when the
Cycle Start Bit turns ON.
DIFU(13) R1
n+3
04
Task Bit
Task 1 05
Task 2
Task 3
Task 4
Function
Section 5-4
Work Bit
OUT
(Ends the block.)
I/O Valid mode
Output Auto