G50: Select Reference Coordinate System - Omron CS1W-MC221 - 02-2008 Operation Manual

G-language Commands
Example 2
N110 G10
N120 G32 X36000 Y100 F1000 O360
N130 G32 X36000 Y-100 F1000 O360
Moves back one
revolution (N130).
Movement of each axis
X axis
Traverse width

7-3-16 G50: SELECT REFERENCE COORDINATE SYSTEM

Format
Operands
Description
416
In this example, just once winding is executed each time at the end. This is an
example of Pass Mode operation combined with G32.
L1
L1
100 windings per layer
One revolution
at the end
100 windings per layer
Y axis
Specifies the reference coordinate system as the coordinate system.
G50
None
This command specifies the reference coordinate system as the coordinate
system. The coordinate data for subsequent axis operations will be processed
as reference coordinate data.
The default setting at the start of program execution will be the reference
coordinate system.
After WORKPIECE ORIGIN RETURN (G27) is executed, the workpiece coor-
dinate system will be used.
Specifies Pass Mode.
Winds one revolution at the end (0 designation).
Moves back to the start.
2 layers
Winds one revolution at the end (N120).
Section 7-3