Chrysler 2005 Crossfire SRT6 Service Manual page 394

5 - 228 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1141-ESP BRAKE PRESSURE SENSOR 1 - PLAUSIBILITY WITH RELEASE SWITCH (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition On. The Controller Antilock Brake (CAB) monitors the status of the ESP
Brake Pressure Sensor.
• Set Condition: The Controller Antilock Brake (CAB) will set this DTC if the calculated ESP Brake Pressure
Sensor 1 is out of the specified range.
ESP BRAKE PRESSURE SENSOR 1
For a complete Antilock Brake System (ABS) Circuit Diagram (Refer to 5 - BRAKES/ELECTRICAL - SCHEMATICS
AND DIAGRAMS).
1.
VISUALLY INSPECT COMPONENTS FOR DAMAGE AND CORRECT INSTALLATION
Visually inspect the ESP Brake Pressure Sensor 1 for damage and correct installation.
Are there any visible Brake Pressure Sensor 1 concerns?
Yes >> Correct the sensor concerns as necessary.
Perform ABS VERIFICATION TEST.
No >> Go to 2
2.
MONITOR THE CAB WITH THE DRB III
With the DRB III , erase DTCs.
Start the engine.
With an assistant to drive, use the DRB III to monitor the CAB mod-
ule DTCs while performing road test.
Is the ESP Brake Pressure Sensor 1 DTC set?
Yes >> Replace the ESP Brake Pressure Sensor 1. (Refer to 5 -
BRAKES/ELECTRICAL/PRESSURE
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Inspect and repair the related wiring harness for a possible
intermittent condition.
Perform ABS VERIFICATION TEST.
POSSIBLE CAUSES
SENSOR -
ZH