Chrysler 2005 Crossfire SRT6 Service Manual page 388

5 - 222 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1140-ESP BRAKE PRESSURE SENSOR 1 CIRCUIT (CONTINUED)
2.
MEASURE THE RESISTANCE BETWEEN THE ESP BRAKE PRESSURE 1 SIGNAL CIRCUIT AND THE
5-VOLT SUPPLY CIRCUIT
Turn the ignition off.
Measure the resistance between the ESP Brake Pressure Sensor 1
Signal circuit and the 5-Volt Supply circuit in the ESP Brake Pressure
Sensor 1 harness connector.
Is the resistance below 100k ohms?
Yes >> Repair the ESP Brake Pressure Sensor 1 Signal circuit for
a short to the 5-Volt Supply circuit.
Perform ABS VERIFICATION TEST.
No >> Go to 3
3.
MEASURE THE RESISTANCE OF THE ESP BRAKE PRESSURE SENSOR 1 SIGNAL CIRCUIT
With the ignition off.
Measure the resistance of the ESP Brake Pressure Sensor 1 Signal
circuit from the CAB harness connector to the ESP Brake Pressure
Sensor 1 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 4
No >> Repair the ESP Brake Pressure Sensor 1 Signal circuit for
an open.
Perform ABS VERIFICATION TEST.
ZH