Chrysler 2005 Crossfire SRT6 Service Manual page 391

ZH
1140-ESP BRAKE PRESSURE SENSOR 1 CIRCUIT (CONTINUED)
9.
MEASURE THE RESISTANCE BETWEEN THE ESP BRAKE PRESSURE SENSOR 5-VOLT SUPPLY
CIRCUIT AND THE SENSOR GROUND CIRCUIT
Turn the ignition off.
Measure the resistance between the 5-Volt Supply circuit and the Sen-
sor Ground circuit.
Is the resistance below 100k ohms?
Yes >> Repair the 5-Volt Supply circuit for a short to the Sensor
Ground circuit.
Perform ABS VERIFICATION TEST.
No >> Go to 10
10.
MEASURE THE RESISTANCE BETWEEN GROUND AND THE ESP BRAKE PRESSURE SENSOR
5-VOLT SUPPLY CIRCUIT
With the ignition off.
Measure the resistance between ground and the 5-Volt Supply circuit.
Is the resistance below 100k ohms?
Yes >> Repair the 5-Volt Supply circuit for a short to ground.
Perform ABS VERIFICATION TEST.
No >> Go to 11
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 225