Chrysler 2005 Crossfire SRT6 Service Manual page 389

ZH
1140-ESP BRAKE PRESSURE SENSOR 1 CIRCUIT (CONTINUED)
4.
MEASURE THE RESISTANCE OF THE ESP BRAKE PRESSURE SENSOR 1 GROUND CIRCUIT
With the ignition off.
Measure the resistance of the Sensor Ground circuit from the CAB
harness connector to the ESP Brake Pressure Sensor 1 harness con-
nector.
Is the resistance below 5.0 ohms?
Yes >> Go to 5
No >> Repair the Sensor Ground circuit for an open.
Perform ABS VERIFICATION TEST.
5.
MEASURE THE VOLTAGE OF THE 5-VOLT SUPPLY CIRCUIT
With the ignition off.
Reconnect the CAB harness connector.
Turn the ignition on.
Measure the voltage of the 5-Volt Supply circuit at the ESP Brake
Pressure Sensor 1 harness connector.
Is the voltage between 4.5 and 5.0 volts?
Yes >> Go to 6
No >> Go to 8
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 223