Emptying The Hole Punch Waste Container - Fuji Xerox Versant 80 Press User Manual

6
Push [R5] until the lock lever moves to the
position.
7
Close the finisher right door.
Note

Emptying the Hole Punch Waste Container

When the optional finisher is installed and the hole punch waste container becomes full, a
message appears on the touch screen. Discard the scrap according to the message.
If you take the hole punch waste container out of the machine, make sure to empty it
completely. If it is reinstalled with some waste remaining, it may become full before the
message appears again, and this can cause machine breakdown.
Important • When emptying the hole punch waste container, make sure that the machine is switched on. If not
1
Make sure that the machine has stopped, and open the finisher right door.
Finisher D4/
Finisher D4 with Booklet/
Finisher D5
• A message will be displayed and the machine will not operate if the finisher right door is even
slightly open.
switched on, the machine will not recognize that the hole punch waste container has been emptied.
• When the machine is in Power Saver mode, exit Power Saver mode by pressing the <Power Saver>
button and the <Machine Status> button on the control panel before you empty the hole punch
waste container.
• Before emptying the hole punch waste container, press the <Machine Status> button and check the
current status for the hole punch waste container even when the control panel is lit.
Replacing Consumables
Finisher C3/
Finisher C3 with Booklet Maker
21
675