Fip1.12 050-131 Iot Remain Zone Duplex Jam; Duplex Regi On Jam - Fuji Xerox DocuPrint M355df Service Manual

FIP1.12 050-131 IOT Remain Zone Duplex Jam

077-107 Duplex Regi On Jam

Step
Parts considered to be the cause
ROLL ASSY DUP (PL14.1.2)
ROLL PINCH DUP (PL14.1.5)
ROLL ASSY EXIT (PL17.1.5)
KIT PINCH ASSY L(PL17.1.6)
KIT PINCH ASSY R(PL17.1.7)
Regi. Sensor [HVPS] (PL18.2.5)
CLUTCH ASSY INVERT (PL3.1.7)
DRIVE ASSY MAIN (PL3.1.1)
PWBA MCU (PL18.2.2)
Check the paper transport path
1 Is there any foreign substances or bits of paper found on
the paper transport path?
Check the paper feed rolls
2 Are the paper feed rolls (the rolls that are listed among the
parts considered to be the cause) installed properly?
Check the paper feed rolls
Are the paper feed rolls (the rolls that are listed among the
3
parts considered to be the cause in sequence) deformed or
worn out?
Check the Regi. Sensor [HVPS] operation
Execute the Diag Digital Input [071-102] to check the oper-
4
ation of the Regi. Sensor [HVPS].
Is the Regi. Sensor [HVPS] operating normally?
Check CLUTCH ASSY INVERT operation
Execute the Diag Digital Output [071-008] to check the
5
operation of the CLUTCH ASSY INVERT.
Is the CLUTCH ASSY INVERT operating normally?
Check the operation of the DRIVE ASSY MAIN
Execute the Diag Digital Output [071-001] to check the
6
rotation of the DRIVE ASSY MAIN.
Is it working properly?
Check and Action
2-57
Chapter 2 Troubleshooting
2.3 Error Code FIP
Yes
Remove the
foreign sub-
stances and Go to Step 2.
bits of paper,
etc.
Go to Step 3. corresponding
paper feed rolls
Replace the
correspond-
Go to Step 4.
ing paper feed
rolls
Go to Step 5.
Step 6
Replace the
PWBA MCU. Go to FIP2.12
(REP 18.2)
No
Reinstall the
Go to FIP2.2
Go to FIP2.7