General Setup - ZyXEL Communications MSC1024G Series User Manual

Chapter 16 Sys Screens
The following table describes the labels in this screen.
Table 267 Access Control: Secured Client
LABEL
Index
Enable
Start Address
End Address
Telnet/SSH/
SNMP/FTP/Web/
ICMP
Apply
Cancel

16.4 General Setup

Click Sys > General Setup from the navigation panel to open the following screen.
512
DESCRIPTION
This is the client set index number. A "client set" is a group of one or more "trusted
computers" from which an administrator may use a service to manage the system.
Select this check box to activate this secured client set. Clear the check box if you
wish to temporarily disable the set without deleting it.
Configure the IP address range of trusted computers from which you can manage
the system.
The system checks if the client IP address of a computer requesting a service or
protocol matches the range set here. The system immediately disconnects the
session if it does not match.
Select services that may be used for managing the system from the specified
trusted computers.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MSC1000G/1024G/1224G Series User's Guide