Profile Ipqos Map Command; Profile Ipqos Delete Command - ZyXEL Communications MSC1024G Series User Manual

Managment switch card

Hide thumbs Also See for MSC1024G Series:

Table of Contents

Chapter 32 profile Commands

This command configures the IPQoS profile's queues.

The following example sets the EXAMPLE IPQoS profile's queue 1 to use a PIR of 1088

kbps, CIR or 1024 kbps, PBS of 3072 bytes, and CBS or 3072 bytes; displays the profile's

settings; and sets the VDSL port 1 in slot 6 to use the profile.

ras> profile ipqos queue EXAMPLE 1 1088 1024 3072 3072

ras> profile ipqos show EXAMPLE

ipqos profile : EXAMPLE

queue number

--- ------ ------ ------ ------ ------ ------

ras> port vdsl ipqos 6-1 EXAMPLE

32.12.4 profile ipqos map Command

profile ipqos map <profile>

This command displays the associated ports using the specified IPQoS profile.

ras> profile ipqos map EXAMPLE

---- ----------------------------------------------------------------------

12345678901234567890123456789012345678901234567890123456789012345678901

2 ------------------------

3 ------------------------

4 ------------------------------------------------

5 ------------------------------------------------

profile ipqos delete <profile>

Set the queue's priority level 0~7. The larger the number, the higher

the priority.

You can configure different IPQoS profiles with queues that have

the same queue priority level. IPQoS then uses Weighted Round

Robin (WRR) scheduling to service these queues on a rotating

basis based on their queue weight. Use these fields to set the

priority weight (1~127) of each queue in an IPQoS profile. The

higher a queue's weight, the more service it gets.

MSC1000G/1024G/1224G Series User's Guide

Msc1224g series Msc1000g series