Table of Contents
Advertisement
Chapter 33 show Commands
The following example displays the Ethernet packet counters for the Ethernet connection to
the line card in slot 1.
ras> show enet up1
slot 1:
link status: up
data rate (Tx/Rx): 0/0 kbps
Bytes
Pkts
UcastPkts
NUcastPkts
McastPkts
BcastPkts
Pause
Pkt64
Pkt65~127
Pkt128~255
Pkt256~511
Pkt512~1023
Pkt1024~1518
Press any key to continue, 'e' to exit
OverSizPkt
UndSizPkt
FCSErr
AlignErr
Jabber
Fragment
Dropped
Underrun
ExCollisn
The following table describes labels in this example.
Table 334 show enet Command Display
LABEL
link status
rate
up time
data rate
(Tx/Rx)
utilization
(Tx/Rx): 0/0
Bytes
Pkts
834
rate: 1000Mbps
utilization (Tx/Rx): 0/0
Rx
-------------------- --------------------
:
357823090
:
969653
:
969652
:
:
:
:
:
:
2146102
:
68655
:
14110
:
19605
:
202045
Rx
-------------------- --------------------
:
:
:
:
:
:
:
:
:
DESCRIPTION
This shows whether or not the port has an active connection.
This shows the connection speed for an active connection.
This shows how long the connection has been active.
This shows at what rate the port is currently sending or receiving data.
This shows what percent the port's current data rate is out of the connection's
maximum rate.
This is the number of octets of Ethernet frames received/transmitted that are from
0 to 1518 octets in size, counting the ones in bad packets, not counting framing
bits but counting FCS (Frame Check Sequence) octets. An octet is an 8-bit binary
digit (byte).
This is the number of packets received/transmitted on this port (including
multicast, unicast, broadcast and bad packets).
up time:
Tx
115120466
1480867
975144
1
505723
0
1
505723
0
0
Tx
0
0
0
0
0
0
0
MSC1000G/1024G/1224G Series User's Guide
6:08:07:50
0
0
0
0
Advertisement
Table of Contents
Troubleshooting
