Profile Alarme1 Delete Command; Profile Alarme1 Map Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 32 profile Commands
qses
quas
dayes
dayses
dayuas
The
alarme1 set
trap and generates a syslog entry when the thresholds of the alarm profile are exceeded.
Configure
them with specific E1 ports.
The following example sets an alarm profile named SESalarm that has the system send an
alarm trap and generate a syslog whenever the E1 connection (from the IMA line card to the
remote ADM device) has more than 3 severely errored seconds within a 15 minute period.
ras> profile alarme1 set SESalarm qses 3

32.7.3 profile alarme1 delete Command

Syntax:
profile alarme1 delete <profile>
where
<profile>
This command allows you to delete an individual E1 alarm profile by its name. You cannot
delete the DEFVAL alarm profile.
The following example deletes the SESalarm alarm profile.
ras> profile alarme1 delete SESalarm

32.7.4 profile alarme1 map Command

Syntax:
profile alarme1 map <profile>
where
<profile>
This command displays which E1 ports are set to use the specified E1 alarm profile.
778
= The number of Severely Errored Seconds (0~900) that are permitted to
occur within 15 minutes.
= The number of UnAvailable Seconds (0~900) that are permitted to occur
within 15 minutes.
= The number of Error Seconds (0~86400) that are permitted to occur within
one day.
= The number of Severely Errored Seconds (0~86400) that are permitted to
occur within one day.
= The number of UnAvailable Seconds (0~86400) that are permitted to occur
within one day.
command configures E1 port alarm thresholds. The system sends an alarm
profiles first and then use the
alarme1
= The name of an E1 alarm profile.
The name of an E1 alarm profile.
=
port e1 alarmprof
MSC1000G/1024G/1224G Series User's Guide
command to use