Rate Limit Profile Setup Screen - ZyXEL Communications MSC1024G Series User Manual

13.26 Rate Limit Profile Setup Screen

Use this screen to set up Ethernet subscriber line transmission rate profiles. You apply the rate
limit profiles to individual Ethernet line card ports (see
this screen, click Profile > Rate Limit.
Figure 257 Profile > Rate Limit
The following table describes the labels in this screen.
Table 172 Profile > Rate Limit
LABEL
Name
Ingress Rate
Egress Rate
Apply
New
Cancel
Index
Name
Ingress Rate
Egress Rate
Select
Modify
Delete
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Enter a descriptive name for the rate limit profile. The name can be 1-31
printable ASCII characters long. Spaces are not allowed.
Set the maximum allowed transmission rate (in kbps) for traffic coming in from
the subscriber. 0 means no limit.
Set the maximum allowed transmission rate (in kbps) for traffic coming going to
the subscriber. 0 means no limit.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
While you are modifying a profile, you can click New to start configuring a fresh
profile without saving your changes.
Click Cancel to start configuring the screen again.
This is an incremental number indicating the order in which the profiles were
created.
This is the name of the profile.
This is the maximum allowed aggregate data transfer rate (in kbps) for traffic
coming in from the subscriber.
This is the maximum allowed aggregate data transfer rate (in kbps) for traffic
coming going to the subscriber.
Select the profile you wish to load or delete.
Select a profile and click this in order to edit its configuration.
Select a profile and click this to delete the profile. Once deleted, information
cannot be retrieved.
Chapter 13 Profile Screens
Section 11.28 on page 291). To open
393