ZyXEL Communications MSC1024G Series User Manual page 910

Chapter 35 sys Commands
Table 348 sys Commands (continued)
COMMAND
trapdst
user
version
syslog disable
enable
server
show
session loginmsg
show
timeout
time set
show
timeserver set
show
910
DESCRIPTION
Sets the IP addresses and listening ports
<index>
for up to four SNMP trap server IP
<destination>
addresses and listening ports. Set 0.0.0.0
[<port>]
to not send any SNMP traps.
[v1|v2c|v3]
name:
[<name>]
packets. Only applicable for V3.
Sets SNMPv3 user name and security
<name>
settings.
noauth|auth|priv
noauth
md5|sha des|aes
and data encryption.
auth
pri
data encryption.
md5|sha
des|aes
Sets the system to use the specified
v2c|v3|v3v2c
SNMP version and access.
v2c
v3
v3v2c
read-only.
Turns off syslog logging.
Turns on syslog logging.
Sets the log facility (local1~local7) to log
<fac> <ip-address>
the syslog messages to a specific file in
the syslog server. See your syslog
program's documentation for details. Sets
the syslog server IP address.
Displays the syslog settings.
Enter a mode that lets you specify a note
to display when users attempt to log into
the system's management interfaces.
Displays the session timeout setting and
the login message.
Specify for how many minutes an
<0~360>
administrator's configuration session can
remain idle before the system
automatically logs the administrator out.
Sets the system time.
<hh> [<mm> [<ss>]]
Displays the current system time.
Clears the time server settings.
none
Sets the time service protocol and IP
daytime <ip-
address of a time server.
address> [sync]
sync:
or
time|ntp <ip-
address> <utc[<+|-
>0100~1200]>
[sync]
Displays the time server settings.
MSC1000G/1024G/1224G Series User's Guide
username to be included in trap
: disables user authentication
: enables user authentication.
: enables user authentication and
: authentication method.
: encryption method.
: SNMPv2 read/write
: SNMPv3 read/write
: SNMPv3 read/write and SNMPv2
Gets the time and date.
P
M
M
M
M
M
M
L
H
L
H
M
L
M
M
L