Profile Vdsl Show Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 32 profile Commands
[fast|delay <us-
delay> <ds-delay>]
[minrate <us-min-
rate> <ds-min-
rate>]
[usmgn <us-max-
mgn> <us-min-mgn>
<us-tgt-mgn>]
The profile is a list of VDSL line configuration settings. After you create a VDSL profile, you
can assign it to any of the VDSL ports on any of the VDSL line cards.
The system rounds the signal to noise margin settings to the nearest multiple
of 0.25 dB.
The following example creates a VDSL profile (named
with very high connection speeds and no interleave delay. It uses the following settings.
• The maximum upstream rate is set to 2048 Kbps.
• The maximum downstream rate is set to 16000 Kbps.
• No interleave delay.
• The minimum upstream is set to 1024 Kbps.
• The minimum downstream is set to 3072 Kbps.
• The maximum, minimum and target acceptable VDSL upstream signal to noise margins
are set to 12, 0 and 6 dB respectively.
• The maximum, minimum and target acceptable VDSL downstream signal to noise
margins are also set to 12, 0 and 6 dB respectively.
ras> profile vdsl set standard 2048 16000 fast minrate 1024 3072 usmgn 12 0
6 dsmgn 12 0 6
This next example creates a similar VDSL profile (named
interleave delay of 16 ms for both upstream and downstream traffic.
ras> profile vdsl set standardB 2048 16000 delay 16 16 minrate 1024 3072 us
mgn 12 0 6 dsmgn 12 0 6

32.16.4 profile vdsl show Command

Syntax:
profile vdsl show [<profile>]
796
= The latency mode. With interleave, you must also define the
upstream and downstream delay (1-255 ms). It is recommended
that you configure the same delay for both upstream and
downstream.
= The minimum VDSL upstream transmission rate (32~45440 Kbps)
and the minimum ADSL downstream transmission rate (32~100032
Kbps).
= The maximum, minimum and target acceptable VDSL upstream
signal to noise margins (0~310 in 0.1 dB measurements).
MSC1000G/1024G/1224G Series User's Guide
) for providing subscribers
standard
), except it sets an
standardB