Chapter 30 multicast Commands
30.12 multicast smcast Commands
Use the following multicast commands to manage static multicast groups.
30.12.1 multicast smcast delete Command
Syntax:
multicast smcast delete <vid> <group-ip>
where
<group-ip>
This command removes a static multicast group entry.
The following example removes a static multicast group for VLAN 23 with static multicast
address 239.255.255.255.
ras> multicast smcast delete 23 239.255.255.255
30.12.2 multicast smcast set Command
Syntax:
multicast smcast set <vid> <group-ip> all|sub1|sub2|up1|up2|<slot-port>
fix|forbid|normal
where
<group-ip>
all|sub1|sub2|
up1|up2|<slot-
port>
fix|forbid|nor
mal
This command configures a static multicast group entry.
The following example creates a static multicast group for VLAN 23. The static multicast
address is 239.255.255.255 and DSL port 9 in slot 7 is a permanent member.
ras> multicast smcast set 23 239.255.255.255 7-9 fix
30.12.3 multicast smcast show Command
Syntax:
multicast smcast show
684
A multicast IP address.
=
A multicast IP address.
=
=
The port or ports to which this static multicast group is to apply.
=
This controls the static multicast group membership status of the port (or
ports).
fix:
Sets the port to be a permanent member of the multicast group.
normal: A
llows the port to join the multicast group when the device adds it
through IGMP protocol.
forbidden:
Prohibits the port from joining the multicast group.
MSC1000G/1024G/1224G Series User's Guide