ZyXEL Communications MSC1024G Series User Manual page 247

Table 98 SHDSL Port Setup (continued)
LABEL
Stuc Alarm Profile
Stur Alarm Profile
Mode
Customer
Information
TEL
Advanced
Features
Apply
Cancel
Copy
ID
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select an alarm profile to define the thresholds that trigger an alarm on the port
when exceeded. This alarm profile is for the STU-C (SHDSL Termination Unit -
Central) end point.
Select an alarm profile to define the thresholds that trigger an alarm on the port
when exceeded. This alarm profile is for the STU-R (SHDSL Termination Unit -
Remote) end point.
Select the type of line coding to use for this port. The STU-R must also support the
same type. Select auto to have the system automatically select the proper line
coding type for the highest possible data rate. PAM 32 is more efficient than PAM
16 and can deliver higher data rates over short distances.
Enter information to identify the subscriber connected to this DSL port. You can
use up to 31 printable English keyboard characters (including spaces and
hyphens).
Enter information to identify the telephone number of the subscriber connected to
this DSL port. You can use up to 15 English keyboard characters (including
spaces and hyphens).
Click the Setup button to open a screen where you can configure the SHDSL
port's detailed settings.
Click Apply to have the specified DSL port use the selected IGMP filter profile.
Click Cancel to set the fields back to the settings that you last retrieved.
Do the following to copy DSL settings from one DSL port to another DSL port or
ports.
1. Use the Slot and Port drop-down list boxes and the Load button to select the
number of the DSL port from which you want to copy settings.
2. Click Copy to open the following screen.
Figure 149 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to
copy the settings. Click Select All to mark all of the port check boxes or click
Select None to clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
This column lists the slot numbers of the line cards. Click the ID number of an
active SHDSL line card to go to a screen where you can copy an SHDSL port's
settings to another SHDSL port.
Chapter 11 Subscriber Port Setup Screens
247