ZyXEL Communications MSC1024G Series User Manual page 558

Chapter 18 VoIP
Figure 383 The VoiP > Countrycode > Detail Screen
The following table describes the labels in this screen.
Table 293 The VoIP > Countrycode > Detail Screen
LABEL
UP
Pulse Parameters
Flash Min / Max (ms)
Break Min / Max (ms) These display the minimum and maximum times for ending a pulse.
Make Min / Max (ms)
Inter-Digit Min (ms)
Meter Parameters
Frequency (kHz)
On Time (ms)
Off Time (ms)
Tones Parameters
Congestion Tone
Special Dial Tone
Call Waiting Tone #2
Howler Tone
Holding Tone
Warning Tone
Confirmation Tone
558
DESCRIPTION
Click this to return to the VoIP > Countrycode screen.
This section displays region-specific information about pulse dialling.
These display the minimum and maximum hook flash times.
These display the minimum and maximum times for beginning a pulse.
This displays the minimum waiting time between pulsed digits.
This section displays region-specific information about call metering.
This displays the frequency of the call-metering tone (in kilohertz).
This displays the duration of the call-metering tone (in milliseconds).
This displays the time between call-metering tones (in milliseconds).
This section displays region-specific information about call progress tones.
This is the tone sent to indicate that the network is busy.
This is the tone sent to indicate that certain three-way calling, conference
and call transfer services are available.
This is reserved for future use.
This is the tone sent to indicate that the handset has been left off-hook too
long.
This is the tone sent to indicate that the call has been put on hold.
This is the tone sent to indicate that the telephone circuit is operating
abnormally.
This is the tone sent to indicate that user-entered information has been
successfully received.
MSC1000G/1024G/1224G Series User's Guide