ZyXEL Communications MSC1024G Series User Manual page 651

where
minlink
This command sets the minimum number of E1 line(s) to automatically activate the related
IMA group when those links are up. When the amount of active E1 line(s) in the IMA group is
less than this number, the IMA group deactivates.
The following example configures IMA group 2 on the IMA in slot 2 using the following
parameters:
• clk: ctc loop
• frame: 128
• framesync: alpha-2, beta-5, gamma-5
• link: 1, 2, 6
• sym: symop
• maxdifdelay: 100 ms
• minlink: 2
ras> ima group clk 2-2 ctc loop
ras> ima group frame 2-2 128
ras> ima group framesync 2-2 2 5 5
ras> ima group link 2-2 1,2,6
ras> ima group sym 2-2 symop
ras> ima group maxdifdelay 2-2 100
ras> ima group minlink 2-2 2
Syntax:
ima group enable <slot-gid>
This command enables an IMA group.
The following example enables IMA group 2 on slot 2.
ras> ima group enable 2-2
Syntax:
ima group show <slot-gid>
This command displays an IMA group's settings.
MSC1000G/1024G/1224G Series User's Guide
= This is the minimum number of E1 lines (1~8) the specified IMA group
should support. Once all of these E1 lines link up, the IMA group
automatically activates. Disconnecting one of these E1 lines deactivates
this IMA group. The fewer E1 lines you configure here the less bandwidth
the link can provide.
Chapter 27 ima Commands
651