Dscp Port Screen - ZyXEL Communications MSC1024G Series User Manual

Figure 65 ACL > DSCP > Setup
The following table describes the labels in this screen.
Table 33 ACL > DSCP > Setup
LABEL
DSCP mapping
(priority)
Apply
Cancel

5.17.2 DSCP Port Screen

Click ACL > DSCP > Port to display the screen shown next. Use this screen to enable or
disable the mapping between DSCP code points and IEEE 802.1p priorities for VLC1324G,
VLC1348G, or ELC subscriber ports.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Use the drop-down list boxes to select an IEEE 802.1p priority to which the Device
should change the DSCP service level.
For example, to find the IEEE 802.1p priority level for DSCP service level 43, find 40
in the left hand column and 3 in the top row. The intersection of the 3 column and 40
row shows a priority setting of 5.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config
Save on the navigation panel and then the Save button to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Chapter 5 Access Control List Screens
127