Acl Rule Screen - ZyXEL Communications MSC1024G Series User Manual

Chapter 5 Access Control List Screens
Figure 62 ACL > Upstream Broadcast
The following table describes the labels in this screen.
Table 30 ACL > Upstream Broadcast
LABEL
Enable
Rate
Apply
Cancel

5.15 ACL Rule Screen

An ACL (Access Control List) profile allows the system to classify and allow or deny
upstream traffic. An ACL profile applies to a PVC.
• Use the Profile > ACL screen
• Use the ACL > Rule screen
PVCs.
Click ACL > Rule to display the screen shown next.
Figure 63 ACL > Rule
124
DESCRIPTION
Click this to enable bandwidth control for upstream broadcast traffic.
Enter the maximum bandwidth for upstream broadcast traffic (in Kbps) allowed to
flow into the line card from a subscriber line.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config
Save on the navigation panel and then the Save button to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
(Section 13.25 on page
(Section 5.15 on page
390) to configure the ACL profiles.
124) to apply the ACL profiles to
MSC1000G/1024G/1224G Series User's Guide