ZyXEL Communications MSC1024G Series User Manual page 225

Table 84 VDSL Port Setup (continued)
LABEL
Alarm Profile
Customer
Information
TEL
PVID / Priority
Advanced
Features
VLAN
PVLAN
Apply
Cancel
Copy
ID
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select an alarm profile to define the thresholds that trigger an alarm on the port
when exceeded.
Enter information to identify the subscriber connected to this DSL port. You can
use up to 31 printable English keyboard characters (including spaces and
hyphens).
Enter information to identify the telephone number of the subscriber connected to
this DSL port. You can use up to 15 English keyboard characters (including
spaces and hyphens).
Specify the port VLAN ID (1~4094) and IEEE 802.1p priority (0~7) to add to
untagged frames received on this port. If an untagged frame matches a PVLAN
setting, the system uses the PVLAN setting instead.
Click the Setup button to open a screen where you can configure the VDSL port's
detailed settings.
Click the Setup button to open a screen where you can configure the VLAN
settings for the VDSL port.
Click the Setup button to open a screen where you can configure Protocol VLAN
(PVLAN) settings for the VDSL port.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy DSL settings from one DSL port to another DSL port or
ports.
1. Use the Slot and Port drop-down list boxes and the Load button to select the
number of the DSL port from which you want to copy settings.
2. Click Copy to open the following screen.
Figure 133 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to
copy the settings. Click Select All to mark all of the port check boxes or click
Select None to clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
This column lists the slot numbers of the line cards. Click the ID number of an
active DSL line card to go to a screen where you can copy an DSL port's settings
to another DSL port.
Chapter 11 Subscriber Port Setup Screens
225